No market can be divided into two types of fluorescent stroboscopic: DC-free communication without stroboscopic stroboscopic lamps and fluorescent lamps. Businessmen and the media as a result of the publicity hype, the emergence of a large number of academic than
Related Articles strong and some dubious publicity terms. From the consumer point of view, many of the light source of knowledge and little electronic knowledge, for those of "justified, said po po
Justified, "the article, which I believe Who? Which products to buy?
For the lifting of consumer confusion, this paper, user-friendly manner, which was more comprehensive analysis of:
First of all, I think that consumer awareness of the need to correct the errors in re-understanding of "no stroboscopic lamps," the essence of the concept. Non-fluorescent stroboscopic light flashing means the convergence degree of volatility
Less than 5%, measured by instruments, "light intensity - duration curve" is basically a straight line, very small fluctuations. It refers to the stroboscopic light source, not the supply voltage of fluorescent lamps
Stroboscopic work.
Have seen an article wrote: "High-frequency stroboscopic oscilloscope still measured in a true face of its strobe can not meet the requirements of non-stroboscopic." As we all know for Oscilloscopes
Used for the electronic measurement instruments, measured only by the post-frequency electronic ballast fluorescent stroboscopic voltage power supply, power supply voltage is the driving force behind the light source, but can not be said that electricity supply
There are strobe output voltage of the fluorescent light intensity stroboscopic there. According to the author's way of thinking, to the driving force behind the representative of the output, then the car is a reciprocating piston engine transport
Moving, the car is running forward - back - forward it? !
Another important term is the afterglow phosphor is fluorescent in the moment after the disappearance of high-energy radiation, light-emitting phosphors remains a phenomenon. Rare earth trichromatic phosphors
Afterglow time is several milliseconds, as a result of this matching lamps use electronic ballasts, high-frequency radiation is far less than the cycle time afterglow phosphor, the brightness of light can not
With the rapid radiation changes, so that the continuous light-emitting phosphors, the light source and light output changes in a very small fluctuations, the achievement of a non-stroboscopic lamps. Since we all ride
Understanding of traffic, with their feet movements Diego, the bike forward, not Diego, the bike is not to stop, but will be free for some time to stop sliding. If the leg when sliding
Tap about the car up and running. Therefore, as long as the control time interval Diego, you can basically achieve uniform car to move on.
Well, DC is no stroboscopic lamps do? We all know that DC is a city of fluorescent after AC-DC power converters for DC fluorescent lamps for use again at the same time it
Will be introduced to the 50Hz alternating current, although only slightly, but resulting in the existence of 100Hz or strobe, and the human eye more sensitive to such stroboscopic.
So, whether it is the exchange of non-stroboscopic stroboscopic fluorescent lamps and DC-free existence in fact very small fluctuations in the strobe, but if in the design of production control the stroboscopic small enough
Degree, the human eye do not feel it is almost there, we think that there is no stroboscopic lamps.
In addition, some articles mentioned in the exchange of non-stroboscopic fluorescent electromagnetic radiation, is not scientific does not exist. We should know that the exchange of non-stroboscopic lamps in the operating frequency
Between 30 ~ 50 kHz, a low frequency band, it is necessary to launch it, at least have a high-power transmitters and several kilometers of transmission antennas!
Integrated speaking, the exchange of non-stroboscopic stroboscopic lamps and DC-free performance in the product evenly matched, we can rest assured that the purchase of use. What is different is the exchange of non-fluorescent stroboscopic
Power factor of 0.9 or above, and no stroboscopic fluorescent DC power factor of about 0.5. In other words, the same brightness of light, no stroboscopic fluorescent exchange capacity than required
DC no less stroboscopic lamps, can be seen that the exchange of non-stroboscopic efficient fluorescent lamp, more energy-efficient.
